Date posted: February 24, 2018

The hot rod we are working on here is roughly 50 years old! If you are going to plan to push the car a bit, it will need support to deal ... [Read More]

Date posted: February 24, 2018

Well almost finished the Chrysler 300 project. Summer cruiser. We had a fairly unseen old school car come into the shop for some maintainen ... [Read More]

Date posted: February 23, 2018

Really nicely built/restored willies with a late model 5.3 swap showed up for some trans tuning. The factory calibrations for these transmis ... [Read More]

Date posted: February 9, 2018

Are you looking to get more low end grunt off the line and lower ET's at the same time? Then look no further than installing a set of steepe ... [Read More]

Date posted: February 9, 2018

Update: the Z car from our exhuast post a couple weeks back has returned for a new clutch and slave cylinder along with the necessary compon ... [Read More]

Date posted: February 8, 2018

We have this Tacoma in the shop for a customer complaint of excessive noise. The truck was just recently purchased but had a large aftermark ... [Read More]

Date posted: January 8, 2018

We had this Mach 1 Mustang in for a torque arm installation. Benefits of this mod include increased rear grip, better launching from a stop, ... [Read More]

Date posted: January 8, 2018

Concerned with excessive engine noise; this '67 Camaro came in to have a look at and see what the issue was. Removing the valve covers revea ... [Read More]

Date posted: January 8, 2018

Subframe connectors are steel tube reinforcements that are welded to the bottom of the car. They connect the front and rear subframes toget ... [Read More]