Date posted: June 10, 2016

A customer brought in this very nice Mustang that he had a fully built 5.4 swapped into the engine bay. Clearance was tight; but with a Lightning MAF and tuning; we were able to get a solid 290 horsepower and 342 ft/lbs ... [Read More]

Date posted: June 10, 2016

Here is a custom '87 Astro with a 383 installed; yes, you read that right...that came in for some performance work. The tired old Quadrajet that was on it had to go; so a new Holley has been ordered and is on its way. St ... [Read More]

Date posted: June 9, 2016

These caster/camber plates are a must for those serious about handling. They allow for optimal alignment settings and to let the car be set up for different usage whether road or track. Theses will also let the steering ... [Read More]

Date posted: June 1, 2016

Customer had a lowered Mustang GT with a Cobra IRS brought in and was after some Koni Sport adjustable shocks. With a simple twist of the knob you can adjust rebound and compression for your driving needs even if goin ... [Read More]

Date posted: June 1, 2016

You don't see many Mark VIIIs on the road; and this is one perfect example. But being a typical Lincoln - it was too quiet for a hot rod guy. We welded on a pair of glasspack mufflers with resonated tips that give it a ... [Read More]

Date posted: June 1, 2016

Concerned with excessive engine noise; this '67 Camaro came in to have a look at and see what the issue was. Removing the valve covers revealed a rocker stud backing out of the block; and a couple vavle springs needed ad ... [Read More]

Date posted: June 1, 2016

We had in this '03 Mach 1 that the customer realized long tubes are the only way to go. Off with the shorty headers and on with the long tubes for awesome sound and of course more power! ... [Read More]

Date posted: May 19, 2016

This '67 Camaro came in to address some driveability concerns and cold start issues; car has a F.A.S.T. programmable engine management system. Found the car had a couple massive engine vacuum leaks; in the runners and th ... [Read More]

Date posted: May 19, 2016

This Cobra is track ready; came in for some unwanted noises coming from the rear end. Replacing a control arm and bushings made this Cobra ready for the circuit again. A Maximum Motorsports front member was also install ... [Read More]
Page 10 of 39« First...89101112...2030...Last »